MB-240X Wheel Balancer
42
P/N 5900262 — Rev. A1 — Jan. 2021
Rotate the Wheel in a clockwise direction again by hand, then increase the speed of rotation using
the Quick Nut handles. When the Wheel gets up to speed, the display should say
run
. After a few
seconds, the Inner and Outer display should read
END CAL
.
Pull the brake handle against the Tire to stop the rotation.
While facing the Wheel, start spinning the Wheel in a clockwise direction. Begin by pushing with
your hand against the Tire, then turn the Quick Nut black handles to increase the speed of rotation
until the Outer Display Window reads
run
.
After a few seconds, the inner and outer display should show weight data for 8 seconds.
Calibration is successful if:
a.
The Balancer weight shows 100 g ±4 grams.
b.
When turning the Wheel slowly to light all the outside Wheel weight indicators the outside
edge 100 gram weight is at the 6 o’clock low position ±4º with all the weight position
indicators lit.
Summary of Contents for MB-240X
