![background image](http://html1.mh-extra.com/html/dannmar/mb-240x/mb-240x_installation-and-operation-manual_3431293034.webp)
MB-240X Wheel Balancer
34
P/N 5900262 — Rev. A1 — Jan. 2021
Turn the Balancer Off and then back On, to reset it.
On power up,
USA 512
will appear in the Inner and Outer Windows, followed by default Wheel
dimensions.
Pull out the Inner Arm and place it against the Inner Edge of the Wheel (where the weight will be
installed) and hold it there; read the distance off the arm and enter this data into the Balancer using
the
Distance
+
/
—
key
.
-A-
will appear in the Inner Display Window and the distance value will
appear in the Outer Display Window.
The Outer Window shows distances in millimeters (mm).
Measure the width of the Wheel using the Wheel caliper. Enter this width into the Balancer using
the
Width
+
/
—
keys.
-L-
will appear in the Inner Display Window and the value will appear in
the Outer Display Window.
Enter the Wheel diameter by reading the size off the Tire sidewall and enter this into the Balancer
using the
Diameter
+
/
—
keys.
-D-
will appear in the Inner Display Window and the diameter
value will appear in the Outer Display Window.
While facing the Wheel, start spinning the Wheel in a clockwise
direction. Begin by pushing with
your hand against the Tire, then turn the Quick Nut black handles to increase the speed of rotation
until the Outer Display Window reads
run.
Release the handles and wait. The display will go blank then the imbalance value will appear in the
Inner and Outer display windows.
When the Wheel stops, look at the value that appears in the Inner Window on the Display Panel;
this is the unbalanced correction weight required for the center plane measured in oz.
The value that appears in the Inner Window needs to be
added to the Center Plane of the Wheel.
Turn the Wheel slowly to find the best location to place
the weight on the
Center Plane
. The Inner Edge/Plane
placement indicators located under the Inner Display
Window light up or go out as you move the Wheel to find the best location to put the weight.
When all the indicators on the Inner plane are lit engage the brake to hold the Wheel and apply the
correct value weight to the center edge of the Wheel at the 12 o’clock position. (If the Inner Display
Window shows
00
, do not add any weight to the center plane).
Press
S + R
to reset the Balancer and test again using the same Wheel values and balance mode.
Spin the Wheel to test the balance again. The Wheel is balanced when both the Inner and Outer
Windows show
00
. It may take several attempts to get the imbalance to 0.
Summary of Contents for MB-240X
