Dannmar MB-240X, Installation And Operation Manual, Page: 24 / 60

MB-240X Wheel Balancer
24
P/N 5900262 — Rev. A1 — Jan. 2021
Viewing/Entering Information on the Display and Control Panel
The Display and Control Panel allows you to enter information about the Wheel you are balancing and
display the test results.
The parts of the Display Panel include:
•
INNER Display Window
. Displays test results and the Wheel parameter to be entered using the
+ / - keys. Value is displayed in the Outer Display Window
.
Parameters displayed include:
o
A – Inside Distance
– the distance from the side of the Balancer to the inner edge of the
Wheel (measured by the Inner Arm) and manually entered.
o
L - Wheel Width – measured using the Wheel Caliper and manually entered.
o
D - Wheel Diameter
- read off the Tire sidewall and manually entered.
• OUTER Display Window . Displays test results and during the Measurements phase, this
Window Displays:
o
Inside Distance (A)
- the distance from the edge of the Balancer to the inner edge/plane
or center plane of the Wheel (measured by the Inner Arm) and manually entered.
o
Wheel Width (L) - measured using the Wheel Caliper and manually entered.
o
Wheel Diameter (D)
- read off the Tire side wall and manually entered.
o
During the test and Weights phase, it displays the weight to be added to the outer plane of
the Wheel.
• Placement Indicators under the INNER Display Window . When Weight needs to be
added to a Wheel, you turn the Wheel slowly and watch the indicators under the inner display
window. When all of the indicators are lit, hold the Wheel in place using the brake. Place the
correction weight at 12 o’clock dead center on the Inner Edge/Plane of the Wheel.
• Placement Indicators under the OUTER Display Window
.
When Weight needs to be
added to a Wheel, slowly turn the Wheel and watch the indicators under the Outer Display