MB-240X Wheel Balancer
35
P/N 5900262 — Rev. A1 — Jan. 2021
Aluminum Alloy Balancing
The following procedure describes the three Aluminum Alloy (ALU) Modes.
Important
: ALU Modes are for balancing Wheels made of aluminum alloy. The weights can be
placed in various locations on these Wheels.
elect the appropriate ALU Mode based on
where the weights will be placed.
Adhesive Weights are generally used when you are
using ALU Modes (there is one exception), as they are less visible than Clip-On
Weights.
To balance a Wheel using an ALU Mode
:
Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
Visually inspect the Balancer to make sure everything is in place.
Mount the Wheel you want to balance.
Refer to
for mounting instructions, if needed.
Turn the Balancer Off and then back On, to reset it.
The instructions for the three ALU Modes are different:
ALU1
ALU1 Mode is used on Aluminum Alloy Wheels when the weights are to be installed on the Inner and
Outer Plane.
Select the ALU 1 Mode by pressing the
F
key until the indicator next to the ALU 1 is lit.
Pull out the Inner Arm and place it on the Wheel Inner Edge and hold it there. Read the distance off
the arm and enter this data into the Balancer using the
Distance
+
/
—
key
.
-A-
will appear in
the Inner Display Window and the distance value will appear in the Outer Display Window.
Return the
inner distance arm to its normal location.
Measure the width of the Wheel using the Wheel caliper. Enter this width into the Balancer using
the
Width
+
/
—
keys.
-L-
will appear in the Inner Display Window and the value will appear in
the Outer Display Window.
Enter the Wheel diameter by reading the size off the Tire sidewall and enter this into the Balancer
using the
Diameter
+
/
—
keys.
-D-
will appear in the Inner Display Window and the diameter
value will appear in the Outer Display Window.
While facing the Wheel, start spinning the Wheel in a clockwise
direction. Begin by pushing with
your hand against the Tire, then turn the Quick Nut black handles to increase the speed of rotation
until the Outer Display Window reads
run.
Release the handles and wait. The display will go blank then the imbalance value will appear in the
Inner and Outer display windows.
Pull the brake to stop the Tire rotation.
Summary of Contents for MB-240X
