Mounting
To adapt to the mounting holes of FC 280, contact the
local Danfoss supplier to order a separate backplate.
To mount the frequency converter:
1.
Ensure that the strength of the mounting location
supports the unit weight. The frequency
converter allows side-by-side installation.
2.
Locate the unit as close to the motor as possible.
Keep the motor cables as short as possible.
3.
Mount the unit vertically to a solid flat surface or
to the optional backplate to provide cooling
airflow.
4.
When provided, use the slotted mounting holes
on the unit for wall mounting.
C
a
b
130BA648.12
f
e
B
A
a
d
e
b
c
Illustration 3.2 Top and Bottom Mounting Holes (See
chapter 9.9 Enclosure Sizes, Power Ratings, and Dimensions
)
3.3.1 Side-by-side Installation
Side-by-side installation
All FC 280 units can be installed side-by-side in vertical or
horizontal position. The units do not require extra
ventilation on the side.
130BE615.10
Illustration 3.3 Side-by-side Installation
CAUTION
RISK OF OVERHEATING
If IP21 solution is used, mounting the units side-by-side
could lead to overheating and unit damages.
•
Avoid mounting the units side-by-side if IP21
solution is used.
3.3.2 Bus Decoupling Kit
The bus decoupling kit ensures mechanical fixation and
electrical screening of cables for the following control
cassette variants:
•
Control cassette with PROFIBUS.
•
Control cassette with PROFINET.
•
Control cassette with CANopen.
•
Control cassette with Ethernet.
Each bus decoupling kit contains 1 horizontal decoupling
plate and 1 vertical decoupling plate. Mounting the
vertical decoupling plate is optional. The vertical
decoupling plate provides better mechanical support for
PROFINET and Ethernet connectors and cables.
Mechanical Installation
VLT
®
Midi Drive FC 280
8
Danfoss A/S © 11/2015 All rights reserved.
MG07A102
3
3