5.8 System Start-up
The procedure in this section requires user-wiring and
application programming to be completed. The following
procedure is recommended after application set-up is
completed.
1.
Press [Auto On].
2.
Apply an external run command.
3.
Adjust the speed reference throughout the speed
range.
4.
Remove the external run command.
5.
Check the sound and vibration levels of the
motor to ensure that the system is working as
intended.
If warnings or alarms occur, see
for resetting the frequency converter after a
trip.
5.9 STO Commissioning
Refer to
chapter 6 Safe Torque Off (STO)
for the correct
installation and commissioning of STO.
Commissioning
Operating Instructions
MG07A102
Danfoss A/S © 11/2015 All rights reserved.
31
5
5
