Danfoss VLT Midi Drive FC 280, Operating Instructions Manual

Page: 23 / 66

130BC506.10
Setup 1
A
B
C
D
5
12
13 14 15
10
11
10
9
6
7
8
4
1
2
3
Menu
Status Quick
Menu
Main
Menu
Hand
On
Off
Reset
Auto
On
Back
OK
On
Warn
Alarm
Illustration 5.1 View of the LCP
A. Numeric display
The LCD-display is back-lit with 1 numeric line. All data is
shown in the LCP.
1 The set-up number shows the active set-up and the edit
set-up. If the same set-up acts as both active and edit set-
up, only that set-up number is shown (factory setting).
When active and edit set-up differ, both numbers are
shown in the display (for example, set-up 12). The number
flashing indicates the edit set-up.
2 Parameter number.
3 Parameter value.
4 Motor direction is shown in the bottom left of the display.
A small arrow indicates the direction, either clockwise or
counterclockwise.
5 The triangle indicates whether the LCP is in Status, Quick
Menu, or Main Menu.
Table 5.1 Legend to Illustration 5.1 , Section A
130BD135.10
Setup 12
INDEX
AHP
VkW
srpm
Hz%
n2 n1 n3
p5 p4
p3 p2 p1
Illustration 5.2 Display Information
B. Menu key
To select between Status, Quick Menu, or Main Menu,
press [Menu].
C. Navigation keys and indicator lights (LEDs)
Key Function
9 [Back] For moving to the previous step or layer
in the navigation structure.
1
0
Arrows [
▲
] [
▼
]
For switching between parameter
groups, parameters, and within
parameters, or increasing/decreasing
parameter values. Arrows can also be
used for setting local reference.
1
1 [OK] Press to access parameter groups or to
enable a selection.
1
2 [
►
] Press to move from left to right within
the parameter value to change each
digit individually.
Table 5.2 Legend to Illustration 5.1 , Navigation Keys
Indicator Light Function
6 On Green ON turns on when the frequency
converter receives power from the
mains voltage, a DC bus terminal, or a
24 V external supply.
7 Warn Yellow When warning conditions are met, the
yellow WARN light turns on and text
appears in the display area identifying
the problem.
8 Alarm Red A fault condition causes the red alarm
light to flash and an alarm text is
shown.
Table 5.3 Legend to Illustration 5.1 , Indicator Lights (LEDs)
D. Operation keys and indicator lights (LEDs)
Key Function
13 Hand On Starts the frequency converter in local control.
•
An external stop signal by control input or
serial communication overrides the local
hand on.
14 Off/Reset Stops the motor but does not remove power
to the frequency converter, or resets the
frequency converter manually after a fault has
been cleared.
15 Auto On Puts the system in remote operational mode.
•
Responds to an external start command by
control terminals or serial communication.
Table 5.4 Legend to Illustration 5.1 , Section D
Commissioning Operating Instructions
MG07A102 Danfoss A/S © 11/2015 All rights reserved. 21
5 5