WARNING
ELECTRICAL HAZARD
Even after pressing the [Off/Reset] key, voltage is present
at the terminals of the frequency converter. Pressing the
[Off/Reset] key does not disconnect the frequency
converter from mains. Touching live parts can result in
death or serious injury.
•
Do not touch any live parts.
5.3.2 The Right-key Function on LCP
Press [
►
] to edit any of the 4 digits on the display
individually. When pressing [
►
] once, the cursor moves to
the first digit, and the digit starts flashing as shown in
. Press the [
▲
] [
▼
] to change the value.
Pressing [
►
] does not change the value of the digits, or
move the decimal point.
130BC440.10
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Illustration 5.3 Right-key Function
[
►
] can also be used for moving between parameter
groups. When in Main Menu, press [
►
] to move to the first
parameter in the next parameter group (for example, move
from
parameter 0-03 Regional Settings
[0] International
to
parameter 1-00 Configuration Mode
[0] Open loop
).
NOTICE
During start-up, the LCP shows the message
INITIALISING
.
When this message is no longer shown, the frequency
converter is ready for operation. Adding or removing
options can extend the duration of start-up.
5.3.3 Quick Menu on LCP
The
Quick Menu
gives easy access to the most frequently
used parameters.
1.
To enter
Quick Menu
, press [Menu] until the
indicator in display is placed above
Quick Menu
.
2.
Press [
▲
] [
▼
] to select either QM1 or QM2, then
press [OK].
3.
Press [
▲
] [
▼
] to browse through the parameters in
Quick Menu
.
4.
Press [OK] to select a parameter.
5.
Press [
▲
] [
▼
] to change the value of a parameter
setting.
6.
Press [OK] to accept the change.
7.
To exit, press either [Back] twice (or 3 times if in
QM2 and QM3) to enter
Status
, or press [Menu]
once to enter
Main Menu
.
Commissioning
VLT
®
Midi Drive FC 280
22
Danfoss A/S © 11/2015 All rights reserved.
MG07A102
5
5
