Danfoss VLT AAF00x, Instruction Manual

Page: 75 / 117

8-35 Minimum Response Delay
Range: Function:
10 ms
*
[Application
dependant] Specify the minimum delay time
between receiving a request and
transmitting a response. This is used
for overcoming modem turnaround
delays.
8-36 Max Response Delay
Range: Function:
Application
dependent
*
[Application
dependant] Specify the maximum
permissible delay time
between transmitting a
request and receiving a
response. Exceeding this delay
time will cause control word
timeout.
8-37 Max Inter-Char Delay
Range: Function:
Application
dependent
*
[Application
dependant] Specify the maximum
permissible time interval
between receiving two bytes.
This parameter activates
timeout if transmission is
interrupted.
This parameter is active only
when
8-30 Protocol is set to FC
MC [1] protocol.
8-53 Start Select
Option: Function:
Select control of the unit start function via the
terminals (digital input) and/or via the Serial
communication bus.
[0] Digital
input Activates Start command via a digital input.
[1] Bus Activates Start command via the serial
communication port or Serial communication
bus option.
[2] Logic
AND Activates Start command via the Serial
communication bus/serial communication port,
AND additionally via one of the digital inputs.
[3]
*
Logic OR Activates Start command via the Serial
communication bus/serial communication port
OR via one of the digital inputs.
NOTE!
This parameter is active only when 8-01 Control Site is set
to [0] Digital and control word.
8-55 Set-up Select
Option: Function:
Select control of the unit set-up selection via
the terminals (digital input) and/or via the Serial
communication bus.
[0] Digital
input Activates the set-up selection via a digital input.
[1] Bus Activates the set-up selection via the serial
communication port or Serial communication
bus option.
[2] Logic
AND Activates the set-up selection via the Serial
communication bus/serial communication port,
AND additionally via one of the digital inputs.
[3]
*
Logic OR Activate the set-up selection via the Serial
communication bus/serial communication port
OR via one of the digital inputs.
NOTE!
This parameter is active only when 8-01 Control Site is set
to [0] Digital and control word.
How to Program VLT Active Filter AAF 00x
6-16 MG.90.V2.22 - VLT
®
is a registered Danfoss trademark
6 6