VLT
®
8000 AQUA
■
Display mode
In normal operation, any 4 different operating variables
can be indicated continuously: 1.1 and 1.2 and
1.3 and 2. The present operating status or alarms
and warnings that have arisen are shown in line 2
in the form of a number. In the case of alarms, the
alarm in question will be shown in lines 3 and 4,
accompanied by an explanatory note. Warnings will
flash in line 2, with an explanatory note in line 1. In
addition, the display shows the active Setup.
The arrow indicates the direction of rotation; here the
frequency converter has an active reversing signal. The
arrow body disappears if a stop command is given or if
the output frequency falls below 0.01 Hz. The bottom
line gives the status of the frequency converter.
The scroll list on the next page gives the operating
data that can be shown for variable 2 in display mode.
Changes are made via the [+/-] keys.
1st line
2nd line
3rd line
4th line
195NA113.10
VAR 2
SETUP
1
STATUS
VAR 1.1 VAR 1.2 VAR 1.3
■
Display mode, cont.
Three operating data values can be shown in the first
display line, while one operating variable can be shown
in the second display line. To be programmed via
parameters 007, 008, 009 and 010
Display read-out
.
•
Status line (4th line):
175ZA701.10
40.0Hz
80.0% 5.08A 2.15kW
SETUP
1
AUTO REMOTE RUNNING
HAND LOCAL STOP
LOCAL STOP
RAMPING
HAND
JOGGING
.
.
.
.
STAND BY
OFF
The left part of the status line indicates the
control ele-ment of the frequency converter that is
active. AUTO means that control is via the control
terminals, while HAND indicates that control is via
the local keys on the control unit.
OFF means that the frequency converter ignores all
control commands and stops the motor.
The centre part of the status line indicates the
refe-rence element that is active. REMOTE means
that the reference from the control terminals is active,
while LOCAL indicates that the reference is determined
via the [+/-] keys on the control panel.
The last part of the status line indicates the current
status, for example "Running", "Stop" or "Alarm".
■
Display mode I
VLT 8000 AQUA offers different display modes
depending on the mode selected for the
frequency converter.
Below is a display mode, in which the frequency
converter is in Auto mode with remote reference
at an output frequency of 40 Hz.
In this display mode, reference and control are
determined via the control terminals.
The text in line 1 gives the operating variable
shown in line 2.
175ZA683.10
SETUP
1
FREQUENCY
40.0Hz
AUTO REMOTE RUNNING
Line 2 gives the current output frequency
and the active Setup.
Line 4 says that the frequency converter is in Auto mode
with remote reference, and that the motor is running.
■
Display mode II:
This display mode makes it possible to have three
operating data values displayed at the same time in
line 1. The operating data values are determined
in parameters 007-010
Display readout
.
175ZA685.10
50.0Hz
SETUP
1
AUTO REMOTE RUNNING
100% 7.8A 5.9kW
■
Display mode III:
This display mode is active as long as the [DISPLAY
MODE] key is kept depressed. In the first line,
MG.83.A2.02 - VLT is a registered Danfoss trademark
86
