94
Status Messages
Status messages appear in the fourth line of the display as shown
below.
The left part of the status line indicates the control point of the drive.
The center part of the status line indicates the reference location.
The last part of the status line gives the present status of the drive.
Auto Mode (AUTO)
The drive is in Auto mode, which means that Run/Stop control is
carried out via the control terminals and/or serial communication. See
also Auto Start .
Hand Mode (HAND)
The drive is in Hand mode, which means that Run/Stop control is
carried out via the keys on the keypad. See also Hand Start.
OFF (OFF)
OFF/STOP is activated either by means of the keypad, or by the digital
inputs Hand Start and Auto Start, both being a logic ‘0’. See also OFF/
STOP .
Local Reference (LOCAL)
If LOCAL has been selected, the reference is set via the + and - keys
on the keypad. See also Display Modes.
Remote Controlled Reference (REM.)
If REMOTE has been selected, the reference is set via the control
terminals or via serial communication. See also Display Modes.
Running (RUNNING)
The motor speed now corresponds to the resulting reference.
Ramp Operation (RAMPING)
The output frequency is changing.
Auto Ramp (AUTO RAMP)
Parameter 208, Automatic Ramp Up/Down, is enabled. The drive is
attempting to avoid a trip from overvoltage by extending its decel ramp
time.
Sleep Boost (SLEEP .BST)
The boost function in parameter 406, Boost Setpoint, is enabled. This
function can only be enabled in Closed Loop operation.
DANGER
!
When in
Sleep Mode, motor may restart at any
time without warning.
Sleep Mode (SLEEP)
The energy saving function in parameter 403, Sleep Mode Timer, is
enabled. This status message shows that at present the motor has been
stopped by sleep mode. It can restart automatically.
DANGER
!
When in
Start Delay mode, motor may restart
at any time without warning.
Start Delay (START DEL)
A start delay time has been programmed in parameter 111, Start Delay.
When the delay has passed, the drive will start and ramp up to the
reference frequency.
DANGER
!
When in
Run Request mode, motor may restart
at any time without warning.
Run Request (RUN REQ.)
A start command has been given, but the motor will not be started until
a Run Permission signal is received via a digital input.
Jogging (JOG)
Jog has been enabled via a digital input or via serial communication.
DANGER
!
When in
Jog Request, motor may restart at any
time without warning.
Jog Request (JOG REQ.)
A start command has been given, but the motor will remain stopped
until a Run Permission signal is received via a digital input.
SETUP
1
80.0% 5.08A 2.15kW
AUTO REMOTE RUN
40.0Hz
HAND
OFF
STOP
RAMPING
JOGGING
.
.
.
.
STAND BY
LOCAL