m Version 3.11
Manual RS.8A.N5.0 © Danfoss 10-007
15
Configuring the System via the Key Pad
Entering Characters in Edit Fields
There are two types of character sets that are used in the m depending on
which edit field has been selected:
Full Character Set
This is used in most of the edit fields. When the edit field has been selected, the
characters within the set can be cycled through using the ‘ ’ or ‘ ’ keys. If the
‘ ’ key is pressed first, it will start at ‘A’ and go forward through the character
set. If the ‘ ’ key is pressed first, it will start at ‘z’ and go backwards through the
character set.
When a character has been selected, press either ‘ ’ to move to the next space
or ‘
↵
’ to move to the next edit field.
Alphanumeric Character Set
If the ‘ ’ key is pressed first, it will start at ‘0’ and go forward through the
character set. If the ‘ key is pressed first, it will start at ‘z’ and go backwards
through the character set.
By pressing the ‘ ’ or ‘ ’ keys, the field is incremented or decremented. By
pressing the ‘ ’ or ‘ ’ keys you can skip across the unit fields to make entering
larger numbers easier.
If your language uses Diacritics (accented characters), the m provides the
facility to enter these both from the local keypad and remotely via PC. This
facility is language sensitive such that only Diacritics which are relevant to the
language active on the unit are available. The method of entry is to select a
base character as normal and then add the required accent, e.g. in French if an
‘é’ is required the procedure is to first select ‘e’ as described above, then enter
Diacritic mode and select the acute accent ´. To enter a Diacritic mode on a
suitable character, hold down the ‘ ’ like a shift key and press the ‘ ’ key once.
This will add the first available accent to your character, any more which are
available can then be selected by pressing the ‘ and ‘ ’ keys together. When
the required accent is displayed, simply moving on to the next character stores
this and cancels the Diacritic mode. If you move the cursor onto an already
accented character, the unit will automatically enter Diacritic mode allowing you
to change the accent. Diacritic mode may be manually cancelled by pressing the
‘ ’ and ‘ ’ once more.
To configure the system via the key pad, select the Setup Menu option from the
Main Menu.
To change any of the configuration information via the keypad, you must first
enter the correct password. The default passcode is 91. However, this may
have been changed to a passcode which is site specific.
Enter in the password using the ‘ ’ or ‘ ’ keys to cycle through the character
list and the ‘ ’ or ‘ ’ key to move the cursor left or right respectively. When the
password is complete, press ‘
↵
’.
The installation name is displayed on the Point Overview screen, the Alarm
History screen, the Event History screen and on the various printouts.
To set the installation name, select the Installation Name option from the Setup
Menu.
Numeric Only Fields
Diacritic Entry
Setup Menu
Entering the Passcode
Setting Installation Name
