Danfoss iC2, Application Manual

Page: 45 / 292

Application Guide | iC2-Micro Frequency Converters
4
Application Software Structure and Overview
4.1
Understanding Application Software Structure
The basic design principle of the application software structure and the related hierarchy refers to the setup of a typical iC2-Micro drive,
as shown in the
Figure 33 .
6 Maintenance & Service
3 Filters & Brake Chopper
5 Application
1 Grid
10 Connectivity
4 Motor
2 Power
Conversion & DC-link
e3
0b
j9
64
.1
0
8 Customization
9 I/O
Figure 33: Application Menu Overview
4.2
Parameter Groups, Related Content, and Settings
l
All generic settings such as Grid, Power Conversion and DC-link, Filters & Brake Chopper, and Motor are accessed via parameter
groups (menu indexes) 1–4.
l
Most of the application-specific parameters are accessed via parameter groups (menu index) 5 Application.
l
Features and functions related to the application such as Maintenance & Service and Customization are in parameter groups (menu
indexes) 6 and 8 respectively.
l
The basic setup for external control signals and communication interfaces is done in parameter groups (menu indexes) 9 and 10
respectively.
l
Features and related parameters are grouped in individual parameter groups. Each feature has a parameter group of its own.
l
Status information for each parameter group is available separately for easy access.
The following table provides information about the parameter groups.
Menu index/Parameter group Parameter group name Description
1 Grid Contains parameters for configuring, monitoring, and controlling the
energy source of the drive system. Typically, the energy source is the
grid. The menu also allows to configure grid protection settings and
view the condition of the grid.
2 Power Conversion Contains parameters to configure, monitor, and control the power
conversion of the drive. The menu allows to configure protection
settings of the power unit and settings for the rectifier, DC link, and
inverter.
3 Filters & Brake Chopper Contains parameters to configure, monitor, and control the filters,
brake chopper, and brake resistors.
4 Motor Contains parameters to configure motor, motor control, and motor
protection.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 |
45