1.
Open protective cover (5).
2.
Set the speed setting (4) to a medium value.
3.
Insert the workpiece.
4.
Close protective cover (5).
5.
Start the motor (1).
6.
Press the foot pedal (3) until the work piece has been cut.
7.
Switch off the motor (2).
WARNING!
Cutting risk
Once the motor has been switched off, the cutting knife will con-
tinue to run for a short time during which there is still a risk of cut-
ting your extremities.
•
Only open the protective cover once the cutting knife has
come to a complete standstill.
8.
Open protective cover (5).
9.
Remove the workpiece.
10. Check the cross section.
11. Adjust the speed setting (4) if necessary.
12. Repeat steps 3
– 11 until the cross section is as desired.
ATTENTION!
Risk of damage to machinery!
Operation with an excessive cutting speed will lead to increased
wear of the cutting knife and may result in damage to the cutting
knife, machine or work piece.
• Always adapt the cutting speed to the work piece diameter.
• Low speed 10 = large work piece diameter
• High speed 0 = small work piece diameter
