Danfoss ET5040 Crimp Machine Operator’s Manual
4 | ©Danfoss ET5040 Crimp Machine Operator’s Manual | 2022.10.
BC425481951279en-000101
Specifications
Machine Setup and Installation
!
NOTE
:
Machine was shipped without Hydraulic Oil:
Customer will need to supply 13.2 gallons or 50 liters of AW46
(ISO46) hydraulic oil, after filling use reservoir cap dip stick to check level. (Note: Do not attempt to run machine prior to filling
with hydraulic fluid).
Weight:
1,050 lbs. (Dry)
Noise Level:
63 dBA
Overall Machine Dimensions:
• Width: 34”
• Depth: 25”
• Height: 52”- 70” (Adjustable
Motor:
5 HP
Figure 1
!
CAUTION
:
Read and understand the operator’s manual before attempting to operate
this machine. Failure to follow operating instructions could result in injury
or damage to the equipment.
Environment
1.
The machine should be installed indoors on a level surface and oper-
ated in a clean dry environment, under normal atmospheric pressure.
Avoid high humidity, dusty environments. (Optimal operating tem-
perature: 50°F to 95°F)
2.
Cover machine when not in use.
Height Adjustment
1.
Machine was shipped with adjustable legs fully retracted.
2.
Remove machine from shipping crate and set in desired production
location.
3.
Use a fork lift to lift the machine to the desired working height.
(See figure 1)
4.
Remove the (4) ball detent pins from each leg and extend the legs to
the desired position and re-insert the ball detent pins.
5.
Confirm all legs are extended the same distance and the ball detent
pins are
!
CAUTION
:
Never get underneath the machine and keep the load low during trans-
port.
Electrical Service Options
Amps
50Hz
60Hz
ET5040-001-230
Crimp Machine, 230V, 3 Phase (50/60 Hz)
16.8
20.6
ET5040-001-380
Crimp Machine, 380V, 3 phase (50/60 Hz)
10.2
12.4
ET5040-001-400
Crimp Machine, 400V, 3 Phase (50/60 Hz)
9.7
11.8
ET5040-001-420
Crimp Machine, 420V, 3 Phase (50/60 Hz)
9.7
11.2
ET5040-001-460
Crimp Machine, 460V, 3 Phase (50/60 Hz)
8.4
10.2
ET5040-001-480
Crimp Machine, 480V, 3 Phase (50/60 Hz)
8.0
9.8
Summary of Contents for ET5040
Page 1: ......