DANA SPICER AXLE 212, Service Manual

Page: 22 / 176

22
ASSEMBLY
Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
ASSEMBLY
FIGURE 11: Accurately clean the piston (9) and the seats of
slide and seal.
Replace the o-rings (11) and (12) and the anti-extrusion rings
(13) and (14); make sure that the assembly side is correct.
Accurately check the positioning of the anti-extrusion rings
(13) and (14).
FIGURE 12: Insert the stroke automatic regulation springs
(15); place them in line with the piston (9).
9
3
14
13
12
11
CAUTION
9
15
15
FIGURE 13: Lubricate the seals (11) and (12) and fit the piston
(9) into the arm (3).
Make sure that the piston seat fits into the stop pin (A) inside
the arm.
FIGURE 14: Assist the insertion of the piston (9) by lightly
hammering around the edge with a plastic hammer.
A
A
9
CAUTION
9