DANA SPICER AXLE 212, Service Manual

Page: 100 / 176

100
ASSEMBLY
Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
ASSEMBLY
FIGURE 11: Screw stem (6) into the piston without locking
the nut (17).
FIGURE 12: Assemble the check unit (7) by inverting the
steps followed in the disassembly procedure.
FIGURE 13: Using a plastic hammer, install the check unit (7)
onto the stem (6).
6
17
B
B
11
11
13
14
14
15 16
6
7
FIGURE 14: Fit the safety snap ring (5) onto the stem (6).
In case the braking disks have been replaced or if brake pi-
stons have been removed: before adjusting the negative
braking unit, apply the brakes several times at maximum
pressure in order to set clearances.
FIGURE 15: Loosen nuts (26) and apply a force of 8 - 10 N
(0.8 - 1 kg) to levers (28). Direct the force towards the braking
direction to eliminate the clearances by using studs (27); lock
nuts (26) to a torque wrench setting of 20 - 25 N·m.
The idle stroke should be eliminated without causing any
preloading.
5
6
7
CAUTION
8√10 N
(0,8 √1 kg)
28
27
26
CAUTION