DANA SPICER AXLE 212, Service Manual

Page: 12 / 176

12
TORQUE SPECIFICATIONS
Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
WHEEL NUT TIGHTENING TORQUES
Wheel nut tightening torques recommended from rim's O.E.M. with reference the the quality of the rim's material.
**RIM'S MATERIAL ST 52 IS RECOMMENDED BY DANA ON AXLE APPLICATION. IT IS THE OPTIMUM MA-
TERIAL FOR TIGHTENING THE RIM TO THE HUB.
*THE TORQUE FIGURE ON NUT AND STUD COUPLING MUST BE RELATED ON STUD MATERIAL QUALITY
(DANA AXLE ARE 10.9 ONLY).
WHEEL NUT TIGHTENING TORQUES
CHARACTERISTICS ILLUSTRATION WHEEL STUD THREAD
RECOMMENDED WHEEL NUTS TORQUE
RIM MATERIAL QUALITY
ST 37 **ST 52
WHEEL NUTS WITH
INTEGRATED
SPHERICAL COLLAR
M18X1,5 mm 330 N·m 460 N·m
M20X1,5 mm 490 N·m 630 N·m
M22X1,5 mm 630 N·m 740 N·m
FLAT COLLAR WHEEL
NUTS WITH SEPARATE
SPHERICAL LOCK
WASHER
M18X1,5 mm 270 N·m 360 N·m
M20X1,5 mm 360 N·m 450 N·m
M22X1,5 mm 460 N·m 550 N·m
WHEEL NUTS WITH
INTEGRATE SEAT
CAPTIVE WASHER
M18X1,5 mm 260 N·m 360 N·m
M20X1,5 mm 350 N·m 500 N·m
M22X1,5 mm 450 N·m 650 N·m
NOTE:
The wheel nut tightening torque is related only on nut thread and stud thread dry. (Without oil or any lubricant).
NOTE:
The wheel nut tightening torque takes into consideration not only the nut + stud characteristics, but also the quality of
the rim material.
THE DANA OFFICIAL TIGHTENING TORQUE TABLE, INCLUDED IN EACH SERVICE MANUAL, SHOWS THE TORQUE FIGURE RELA-
TED TO THE BOLT CHARACTERISTIC ONLY .
DANA OFFICIAL TIGHTENING TORQUE TABLE
NUT MATERIAL QUALITY 8.8 & 10.9 STUD MATERIAL QUALITY 10.9 *ALLOW TIGHT TORQUE
M18 x 1,5 mm M18 x 1,5 N·m 442 - 489 N·m
M20 x 1,5 mm M20 x 1,5 N·m 613 - 677 N·m
M22 x 1,5 mm M22 x 1,5 N·m 822 - 908 N·m