Dalsa Piranha3, User Manual

Page: 83 / 91

Piranha 3 User Manual
DALSA 03-032-10216-02
83
Command Syntax Parameters Description
set sync frequency
ssf i
Set the frame rate to a value from:
12k:
300
-
23619
Hz
8k:
300
-
33855
Hz
Value rounded up/down as required.
Refer to section 3.2.1 Exposure Mode,
Line Rate and Exposure Time for details.
set system gain
ssg t i
Set the digital gain.
t
= Tap value.
0
for all taps or
1
to
8
for
individual tap selection.
i
= Gain value is specified from
0
to
65535
. The digital video values are
multiplied by this number.
Refer to Setting Digital System Gain on
page 48 for details.
set upper threshold
sut i
Set upper threshold that is check for and
reported in the end-of-line sequence to a
value from
0
-
4095
. Refer to section 3.4.3
End-of-line Sequence for details.
set video mode
svm i
Switch between normal video mode and
test patterns:
0
: Normal video mode
1
: 12 bit ramp test pattern
2
: 8 bit step test pattern
Refer to section 3.6.1 Generating a Test
Pattern for details.
update gain reference
ugr
Changes the 0dB gain to equal the
current analog gain value set with the
sag
command.
verify temperature
vt
Get the internal temperature of the
camera
verify voltage
vv
Get the camera input voltage
write FPN coefficients
wfc
i
Write all current FPN coefficients to
EEROM where
i
is:
1
= FPN coefficient set one
2
= FPN coefficient set two
3
= FPN coefficient set three
4
= FPN coefficient set four
Refer to section 3.5.1 Saving and
Restoring PRNU and FPN Coefficients
for details.
write pixel coeffs
wpc
i
Write all current PRNU coefficients to
EEROM where
i
is:
1
= PRNU coefficient set one
2
= PRNU coefficient set two
3
= PRNU coefficient set three
4
= PRNU coefficient set four
Refer to section 3.5.1 Saving and
Restoring PRNU and FPN Coefficients
for details.