Piranha ES-xx User Manual
Teledyne DALSA
03-032-20070-02
23
2
Camera Hardware
Interface
2.1 Installation Overview
When installing you r cam era, you shou ld take these step s:
1.
Pow er d ow n all equ ip m ent.
2.
Follow the m anu factu rer’s instru ctions to install the fram e grabber (if ap p licable). Be
su re to observe all static p recau tions.
3.
Install any necessary im aging softw are.
4.
Before connecting p ow er to the cam era, test all p ow er su p p lies. Ensu re that all the
correct voltages are p resent at the cam era end of the p ow er cable. Pow er su p p lies
m u st m eet the requ irem ents d efined in section 2.2.2 Pow er Connector.
5.
Insp ect all cables and connectors p rior to installation. Do not u se d am aged cables or
connectors or the cam era m ay be d am aged .
6.
Connect Cam era Link and p ow er cables.
7.
After connecting cables, ap p ly p ow er to the cam era.
8.
Check the d iagnostic LED. See 2.2.1 LED Statu s Ind icator for an LED d escrip tion.
You m u st also set u p the other com p onents of you r system , inclu d ing light sou rces,
cam era m ou nts, host com p u ters, op tics, encod ers, and so on.
2.2 Input/Output Connectors and LED
The cam era u ses:
A d iagnostic LED for m onitoring the cam era. See LED Statu s Ind icator in section 2.2.1
LED Statu s Ind icator for d etails.
H igh-d ensity 26-p in MDR26 connectors for Cam era Link control signals, d ata signals,
and serial com m u nications. Refer to section 2.2.3 Cam era Link Data Connector for
d etails.
This installation
overview assumes you
have not installed any
system components yet.
Summary of Contents for Piranha ES Series
Page 22: ...Piranha ES xx User Manual 03 032 20070 02 Teledyne DALSA 22 ...
Page 88: ...Piranha ES xx User Manual 03 032 20070 02 Teledyne DALSA 88 ...
Page 102: ...Piranha ES xx User Manual 03 032 20070 02 Teledyne DALSA 102 ...
Page 104: ...Piranha ES xx User Manual 03 032 20070 02 Teledyne DALSA 104 ...
