DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
54
Dallmeier electronic
8.4.1.2
Motion
The Motion recording mode analyzes every image send by the camera. If a change of a
certain proportion of the picture content is detected between two consecutive images, an
image comparison event (event) has taken place. This picture comparison event triggers
the recording.
Recording will be stopped when the
Post-Event time
is expired and no further motion is
detected.
Ø
Ensure that the
Expert Mode
option is activated.
Ø
Set the
Motion
recording mode.
Ø
Observe the explanations given below.
Fig. 8-18:
Motion
recording mode
Ø
Configure
Private Zones
if required (see chapter
Basic configuration
).
Ø
Activate / configure the
Camera Timer
if required (see chapter
Basic configuration
).
Ø
Activate the
Use Database
option if required.
Ø
Configure the
Active Areas
if required (see chapter
Basic configuration
).
Ø
Set the
Sensitivity
of the motion detection.
Ø
Set the
Pre-Event
time and the
Post-Event
time.
Ø
Set the
Motion Estimation
for the memory calculation.
Ø
Confirm with
OK
.
Sensitivity
The more sensitive the image comparison is, the less the proportion of the picture contents
must change to trigger an image comparison event.
Pre-Event time
This option enables you to set a period during which the latest images from the camera are
retained in a buffer. If an event occurs these images are saved together with the recording
in the track. This allows the situation prior to the event to the evaluated.
Post-Event time
The Post-Event time specifies how long a picture comparison event is valid. Whilst it is valid
all subsequent picture comparison events will be assigned to it without triggering a new
event. The
Post-Event time
is used to prevent an excessive number of events.
