DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
58
Dallmeier electronic
Ø
Configure the Active Areas if required (see chapter Basic configuration).
Ø
Set the
Sensitivity
of the motion detection.
Ø
Set the
Motion Estimation
for the memory calculation.
Ø
Set the
Pre-Event time
and the
Post-Event time
.
Ø
Configure
Private Zones
if required (see chapter
Basic configuration
).
Ø
Activate / configure the
Timer
if required (see chapter
Basic configuration
).
Ø
Activate the
Use Database
option if required.
Ø
Set an option (
Event
,
Save
,
Mark
) if required (see above).
Ø
Confirm with
OK
.
Sensitivity
The more sensitive the image comparison is, the less the proportion of the picture contents
must change to trigger an image comparison event.
Motion Estimate
This value specifies the estimated percentage of images with motion. It affects only the
estimated recording duration (
Estimate
) in the track.
Pre-Event time
This option enables you to set a period during which the latest images from the camera are
retained in a buffer. If an event occurs these images are saved together with the recording
in the track. This allows the situation prior to the event to the evaluated.
Post-Event time
The
Post-Event time
specifies how long a picture comparison event is valid. Whilst it is
valid all subsequent picture comparison events will be assigned to it without triggering a new
event. The
Post-Event time
is used to prevent an excessive number of events.
8.4.2.3
Contact
In the
Contact
recording mode the recording is triggered by the recorder’s contact IN func
-
tions. Contrary contact functions or completion of an
Option
will stop the recording.
Note that a contact input must be configured for the relevant camera (see chapter
Contact
IN
).
Ø
Set the
Contact
recording mode.
Ø
Observe the explanations given below.
Fig. 8-22:
Contact
recording mode
