Daktronics ST-3170, Manual, Page: 19 / 50

Mechanical Installation
15
5� Grab and lift up on the rear of the left caster base pivot arm to raise that side of the
table off the floor. Refer to Figure 27 . Again, the tabletop should be pushed up flush
against the rear of the display cabinet to be secured in place by the pivot arms.
CAUTION! Keep fingers/thumb clear between the top of the pivot arms and tabletop
surface to avoid being pinched.
Figure 27: Raise Pivot Arm (Left Caster Base)
6� Move to the right side caster base pivot arm and repeat Step 5 to fully lift the table
off the floor. Refer to Figure 28 .
Figure 28: Raise Pivot Arm (Right Caster Base)
7� Place the Caster Base Tools back in the bottom channel of each caster base. Refer
to Figure 12 .
8� At this point, the table is back in transport mode and can be moved to storage or an
alternate location. Refer to Figure 29 .
PINCH
POINT
!