Dakota Ultrasonics
2
CHAPTER TWO
QUICK STARTUP GUIDE
Turn the
PVX-B
on and off using the switch located on the bottom right corner of the
keypad. When
PVX-B
is initially turned on, a flash logo and blinking lights will be
displayed prior to entering into the main measurement screen. Note: This section is
primarily written as a basic startup guide only.
2.1 Selecting the Transducer Type
The first step in using the
PVX-B
is to select the transducer type stored in a setup.
There are 18 factory setups containing different transducer types that can be loaded,
modified and stored in a new setup location. By selecting the transducer type from a
predefined setup list, the
PVX-B
can recall specific properties about the transducer,
setup the display area and predefined scope settings.
Note:
Once the transducer
has been selected, the
PVX-B
will store and recall this setup, containing the
transducer type, every time the
PVX-B
is powered on/off. This setup will only change
if the user physically selects another setup from the list. Therefore, if you have
previously gone through this section and selected the appropriate setup, proceed to
the next section. Use the following steps to select your setup (transducer type):
Selecting a Setup for use with a specific Transducer Type
1) Press the
MULTI MODE
key once to activate the load setup list containing
the transducer types and settings.
2) Use the
UP
and
DOWN
arrow keys to scroll through the setup list until the
target setup is highlighted.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
