Dakota Digital BIM-01-2-HSN2, Quick Start Manual, Page: 7 / 10

[7] MAN #650832
BIM setup:
BIM menu table:
Menu Options Default Notes
   
For Terminator HP and Dominator systems
   
For Sniper EFI
   
For Terminator X and Terminator X Max
   
   
Input 1 speed enable, only in menu when

is set to

(HP & Dominator)
   
   
   
For a handheld display connection to the Holley ECU.
    
(handheld connected) or

(handheld not connected).
   
   
Gauge will display MAP/vacuum reading *** Terminator X cannot read MAP
   
Gauge will display boost
   
   
Update communications with other BIM modules attached
   
   
Exit Setup.
   
System Selection for Holley module
The BIM-01-2-HLLY must be configured for the correct type of Holley EFI system being used.
•
Hold the switch on the BIM-01-2-HLLY case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Release the switch.
•
The BIM module should display

(System). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current system

,

, or

•
Tap the switch to change the system.
o
 – Standard = Dominator or Terminator HP
o
 – Sniper
o
 – Terminator X only
•
To save setting press and hold the switch until you see
“  ” on the display, then release the switch.
• The display will show “  ”. Press and hold the switch to exit setup or tap to choose another menu option.
Enable or disable ability to read speed (HP and Dominator

=

)
Not an option when

is set to

or

With the configuration of the speed input in either the Dominator or Terminator HP, the BIM-01-2-HLLY has the option
•
Hold the switch on the BIM-01-2-HLLY case while turning the key on. The BIM display will show the current
revision code while this is held.
•
Release the switch.
•
Tap the switch until the display shows

(input). Press and hold to enter this menu.
•
When you see
“  ” on the display release the switch.
•
The display will show the current state or the speed input

(enable) or

(disable).
•
Tap the switch to change the state.
•
To save setting press and hold the switch until you see
“  ” on the display, then release the switch.
•
The display will show

. Press and hold the switch to exit setup or tap to choose another menu option.