[1]
MAN #650832
BIM-01-2-HSN2
Bus Interface Module for Holley Sniper 2
This Bus Interface Module is designed to read engine information from the Holley Sniper 2 kits. The module is connected
to the Holley EFI through the CAN-bus plug on the EFI harness. To connect your Sniper 2 to this product, disconnect the
4-pin threaded connector that links your throttle body to the Sniper 2 handheld. Then, connect these cables to the 391205
included in this kit. Connect the 391205 to the BIM-01-2-HLLY using the included 394298 harness.
There are two interface (I/O) ports on the BIM-01-2-HLLYmodule. Either one can be connected to the instrument system
or to another module, allowing several units to be daisy chained together.
Cannot daisy chain with GPS-50-2
.
Do not connect the I/O port to anything other than a Dakota Digital control box or BIM.
Do not mount the module in the engine compartment; as
it should be mounted in the vehicle’s cabin.
The engine and transmission information that is available from the unit depends on the EFI kit and module programming
and add-ons. For specific data readings: see individual setups below for each version of Holley EFI system below.
Note: If you are not utilizing a Holley handheld display, you must disable the HND setting within this BIMs
setup menu (Page 9-10). With the HND setting disabled, you must unplug this BIM unit if you perform a
Holley firmware update using Holley’s CAN to USB adapter.
A GPS-50-2 CANNOT be linked (daisy chained) to a BIM-01-2 with a BIM cable.
The two units cannot talk to the display control box at the same time.
391205
394298
