[4]
MAN #650832
VHX Setup:
Entering the VHX setup is done by holding SW1 (I) and tur
ning the ignition to “on”, or “acc”.
Once in setup, one can move between
speed
,
tach
,
volt
,
water
, etc…. by tapping SW1 (I)
If you are setting multiple items, once done with one section you will automatically move onto the next item.
Obtaining RPM from the BIM-01-2-HLLY
•
Hold the SW1 (I) switch from the instrument system control box while turning the key on.
o
The message display should show
SETUP
.
•
Release SW1 (I) - LCD1 should show
SETUP SPEED
.
•
Tap SW1 (I) until
SETUP TACH
is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until
TACH ENGINE
is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until
ENGINE
is displayed.
•
Release the switch and
ENGINE 8
will be displayed.
•
Tap SW1 (I) until
ENGINE BUS
is displayed.
•
Press and hold SW1 (I) until
DONE
is displayed.
•
Tap SW1 (I) until
TACH DONE
is displayed.
•
Press and hold SW1 (I) until a big
DONE
is displayed.
Obtaining engine temperature from the BIM-01-2-HLLY
•
Hold the SW1 (I) switch from the instrument system control box while turning the key on.
o
The message display should show
SETUP
.
•
Release SW1 (I) - LCD1 should show
SETUP SPEED
.
•
Tap SW1 (I) until
SETUP WATER
is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until
WATER SENDER
is displayed.
•
Press and hold SW1 (I) for at least 3 seconds until
SENDER DD F
is displayed.
•
Release the switch and
SENDER DD F
will be displayed.
•
Tap SW1 (I) until
SENDER BUS F
(Fahrenheit) is displayed.
o
Tap SW1 (I) once more for
SENDER BUS C
(Celsius) if desired.
•
Press and hold SW1 until
DONE
is displayed.
•
Tap SW1 (I) until
WATER DONE
is displayed.
•
Press and hold SW1 (I) until a big
DONE
is displayed.