www.daisalux.com
14
LPS24
– USER MANUAL
6.3.3. Auxiliary inputs (AUX1, ..., AUX4)
The system has four auxiliary inputs configurable with different actions. The available
options are shown in the table below
!
Maximum line impedanc
e < 1kΩ.
Auxiliary
switch on
Switching on all luminaires in the system
DBR switch on
Switching on the ELC luminaires in DBR mode that have this
functionality
Auxiliary
switch on and
DBR on
Switching on all luminaires in the system and switching on DBR on
those that have this functionality
Remote mains
failure
Switching on all luminaires due to power failure in another part of the
facility
Switch On/off
Switching on (on activation of the input) or off (on deactivating the
input) the circuits associated to the auxiliary input when connected to
power. Valid for circuits configured in “
not connected
” or “
beacons
”
mode. This configuration takes precedence over the
permanent
/
non-
permanent
circuit configuration.
6.3.3.1 Remote fault connection to one LPS24 device
To switch on all the luminaires in case of remote network failure, the “AUX” (auxiliary
inputs) must be connected to the DR-
3 “NO” (normally open) contact (three
-phase power
detector). The DR-3 must be connected in serial form as shown in the image below to
monitor more than one remote fault:
