daisalux LPS24, User Manual

Page: 33 / 39

www.daisalux.com
33
LPS24
– USER MANUAL
8.2.7. Appendix
8.2.7.1. Alert messages
When the device detects an alert, a pop-up is generated on the display with the error
message. The user can remove the pop-up by pressing the
OK or
←
key.
Below is a list of the alerts available and an explanation.
Alert Description
End of bat discharge log A record indicating that the device has been in standby since reaching
the end of discharge
Battery is running down The device detects that it has energy for less than 10 minutes
Input overvoltage The device has detected a voltage on the input well above its nominal
voltage
System overload
The device has detected that the load connected is higher than its
maximum power
Mains failure Mains failure on the unit’s input.
Remote mains failure Mains failure in a remote mains detector associated with the device
Global siwtch on active Active auxiliary switch on
DBR switch on active Active DBR switch on
Internal voltage error Voltage generated by the rectifier outside of range
Battery voltage error Battery voltage out of range
Wrong battery temperature Temperature in the battery compartment outside of range
Function test on course The device is running a functional test
Duration test on course The device is running a duration test
Capacity test on course The device is running a capacity test
Circuit test on course The device is running a circuit test
Duration test required The duration test period has transpired without a test having been
performed. A test must be run to check the system’s duration
Function test failure Fault detected in the last functional test
Duration test severe fail A serious fault was detected during the last duration test (duration less
than 60% of the nominal duration)
Duration test light fail A minor fault was detected during the last duration test (duration higher
than 60% and lower than 100% of the nominal duration)
Battery bad connected Incorrectly connected battery
Battery open Battery open or in bad state
Battery not symmetric Batteries not symmetrical. Possible fault in a battery
Battery fuse failure Fault in any of the battery fuses
Temperature sensor failure Failure in the communication with the temperature probe
Output circuit failure A circuit fault
Battery charge failure Battery charge regulation fault
Rectifier failure Failure in the rectifier
Electronic failure Fault in the device’s electronics. Requires repair
Contactor open Contactor open. Installation uncertain in the event of power failure.
Zoning on course The device is running a zoning process
Shutting down … The device is in standby
Command executed User command executed
Password: 0000 Request the password required to edit the value or execute the order
Low security The device estimates that the installation requires maintenance
Very low security The device estimates that the installation is unsafe