4
English
4. PREPARATIONS BEFORE INSTALLA-
TION
(1) Relative positions of indoor unit, suspension bolt, pip-
ing hole, drain piping hole, and electric wire hole posi-
tion. (Refer to Fig. 2)
(2) Make the suspension bolt hole, piping hole, drain pip-
ing hole.
• Refer to the paper pattern for installation for hole posi-
tions.
• Fix the positions for suspension bolt, piping hole, drain
piping hole, and electric wire hole, and make the open-
ings.
(3) Detach the parts for indoor unit.
1) Detach the suction grille.
• Slide the suction grille fixing knobs (2 parts) backward
(arrow direction) and open the suction grille widely.
(Refer to Fig. 3)
• Keep the suction grille opened. Holding the knob on the
back of suction grille, pull to the front direction to
remove.
(Refer to Fig. 4)
2) Detach the dressing boards (left and right).
• Remove the side panel fixing screw 1) and pull to the
front direction (arrow direction) to remove.
(Refer to Fig. 5)
• Pull out of the accessories.
3) Remove the hanger bracket.
• Loosen two hanger bracket setting bolts (M8) (two on
each side) on each side for less than 10 mm.
(Refer to Fig. 6 and 7)
• Remove two hanger bracket fixing bolts (M5) on the
rear side. Detach the hanger bracket by pulling back-
wards.
(Refer to Fig. 7)
Model
A
B
C
D
E
F
G
FXHQ32M(A)VE
960
920
390
375
310
400
375
FXHQ63M(A)VE
1160 1120
490
475
410
500
475
FXHQ100M(A)VE
1400 1360
610
595
530
620
595
160
135
F
G
Rear side piping hole
(
φ
100 )
Left side piping hole
Front view
A (Decoration panel)
B (Suspension bolt pitch)
B
(Suspension
bolt
pitch)
85
185
160
210
260
680
(Decoration
panel)
C
D
E
Top side drain
piping hole
Top liquid hole
Top gas
piping hole
Suspension
bolt (×4)
Air outlet
False ceiling view
(length : mm)
Fig. 2
Fig. 3
Fig. 4
Accessories
Dressing board securing
screw (M4)
Dressing board
Fig. 5
Indoor unit
Hanger bracket
Max. exposed
thread 10 mm
Fig. 6
Hanger bracket
fixing screw (M5)
Hanger bracket
Hanger bracket
setting bolt (M8)
Fig. 7
01_EN_3P172532-7.fm Page 4 Thursday, December 15, 2005 2:45 PM
