Daikin FXHQ32MVE Installation Manual Download

Page: 4 / 15

English

(b) where corrosive gas, such as sulfurous acid gas, is pro-

duced
Corroding copper pipes or soldered parts may result in
refrigerant leakage.

Electromagnetic waves may disturb the operation of the
control system and result in a malfunction of the equip-
ment.

(d) where flammable gases may leak, where there are car-

bon fiber or ignitable dust suspensions in the air, or
where volatile flammables such as thinner or gasoline
are handled.
Operating the unit in such conditions may result in
fire.

2. BEFORE INSTALLATION

•

When moving the unit while removing it from the carton
box, be sure to lift it by holding on to the four lifting lugs
without exerting any pressure on other parts, especially,
the refrigerant piping, drain piping, and other resin
parts.

• Be sure to check the type of R410A refrigerant to be used

before installing the unit. (Using an incorrect refrigerant will
prevent normal operation of the unit.)

• The accessories needed for installation must be retained in

your custody until the installation work is completed. Do not
discard them!

• Decide upon a line of transport.
• Leave the unit inside its packaging while moving, until reach-

ing the installation site. Where unpacking is unavoidable, use
a sling of soft material or protective plates together with a
rope when lifting, to avoid damage or scratches to the unit.

• When selecting installation site, refer to the paper pattern.
• For the installation of an outdoor unit, refer to the installation

manual attached to the outdoor unit.

• Do not install or operate the unit in rooms mentioned below.

•

Laden with mineral oil, or filled with oil vapor or spray
like in kitchens. (Plastic parts may deteriorate which
could eventually cause the unit to fall out of place, or
could lead to leaks.)

•

Where corrosive gas like sulfurous gas exists. (Cop-
per tubing and brazed spots may corrode, which
could eventually lead to refrigerant leaks.)

•

Where exposed to combustible gases and where vol-
atile flammable gas like thinner or gasoline is used.
(Gas in the vicinity of the unit could ignite.)

•

Where machines can generate electromagnetic
waves. (Control system may malfunction.)

•

Where the air contains high levels of salt such as that
near the ocean and where voltage fluctuates greatly
such as that in factories.
Also in vehicles or vessels.

• This unit, both indoor and outdoor, is suitable for installation

in a commercial and light industrial environment.
If installed as a household appliance it could cause electro-
magnetic interference.

2-1

PRECAUTIONS

• Be sure to read this manual before installing the indoor unit.
• Entrust installation to the place of purchase or a qualified ser-

viceman. Improper installation could lead to leaks and, in
worse cases, electric shock of fire.

• Use only parts provided with the unit or parts satisfying

required specifications. Unspecified parts could cause the
unit to fall out of place, or could lead to leaks and, in worse
cases, electric shock or fire.

2-2

ACCESSORIES

Check the following accessories are included with your
unit.

2-3

OPTIONAL ACCESSORIES

• These are two types of remote controllers: wired and wire-

less. Select a remote controller according to customer
request and install in an appropriate place.

NOTE

• If the you wishes to use a remote controller that is not listed

above, select a suitable remote controller after consulting
catalogs and technical materials.

Name

(1) Drain hose