![background image](http://html2.mh-extra.com/html/daikin/ftxtj30a2v1bw/ftxtj30a2v1bw_installation-manual_5692481008.webp)
7 Electrical installation
Installation manual
8
FTXTJ-A(W)(B)
Daikin room air conditioner
3P695637-3C – 2023.03
WARNING
If the supply cord is damaged, it MUST be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING
Do NOT connect the power supply to the indoor unit. This
could result in electrical shock or fire.
WARNING
▪ Do NOT use locally purchased electrical parts inside
the product.
▪ Do NOT branch the power supply for the drain pump,
etc. from the terminal block. This could result in
electrical shock or fire.
WARNING
Keep the interconnection wiring away from copper pipes
without thermal insulation as such pipes will be very hot.
7.1
Specifications of standard wiring
components
NOTICE
We recommend using solid (single-core) wires. If stranded
wires are used, slightly twist the strands to consolidate the
end of the conductor for either direct use in the terminal
clamp or insertion in a round crimp-style terminal. Details
are described in "Guidelines when connecting the electrical
wiring" in the installer reference guide.
Component
Interconnection cable
(indoor↔outdoor)
Voltage
220~240 V
Wire size
Only use harmonized wire
providing double insulation
and suitable for applicable
voltage
4-core cable
1.5 mm²~2.5 mm
2
(based on
outdoor unit)
7.2
To connect the electrical wiring to
the indoor unit
WARNING
Provide adequate measures to prevent that the unit can be
used as a shelter by small animals. Small animals that
make contact with electrical parts can cause malfunctions,
smoke or fire.
NOTICE
▪ Keep the power line and transmission line apart from
each other. Transmission wiring and power supply
wiring may cross, but may NOT run parallel.
▪ In order to avoid any electrical interference, the
distance between both wirings should ALWAYS be at
least 50 mm.
Electrical work should be carried out in accordance with the
installation manual and the national electrical wiring rules or code of
practice.
1
Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
a
b
c
d
a
Mounting plate (accessory)
b
Piece of packing material
c
Interconnection cable
d
Wire guide
INFORMATION
Support the unit using a piece of packing material.
Example:
2
Open the front panel, and then the service cover. Refer to the
Installer reference guide for opening procedure. For location of
the installer reference guide refer to
3
Pass the interconnection cable from the outdoor unit through
the feed-through wall hole, through the back of the indoor unit
and through the front side.
Note:
In case the interconnection cable was stripped in advance,
cover the ends with insulating tape.
4
Bend the end of the cable up.
a
b
c
a
Terminal block
b
Electrical component block
c
Cable clamp
5
Strip the wire ends approximately 15 mm.
6
Match wire colours with terminal numbers on the indoor unit
terminal blocks and firmly screw the wires to the corresponding
terminals.
7
Connect the earth wire to the corresponding terminal.
8
Firmly fix the wires with the terminal screws.
9
Pull the wires to make sure that they are securely attached,
then retain the wires with the wire retainer.
10
Shape the wires so that the service cover fits securely, then
close the service cover.
Summary of Contents for FTXTJ30A2V1BW
Page 14: ......
Page 15: ......
Page 16: ...3P695637 3C 2023 03 Copyright 2023 Daikin Verantwortung f r Energie und Umwelt...