Daikin FTXTJ30A2V1BW, Installation Manual

Page: 4 / 16

4 About the unit
Installation manual
4
FTXTJ-A(W)(B)
Daikin room air conditioner
3P695637-3C – 2023.03
d Titanium apatite deodorising filter and silver particle filter
(Ag-ion filter)
e Indoor unit fixing screw (M4×12L). Refer to "8.3 To fix the
unit on the mounting plate" [
4
10].
f Dry battery AAA.LR03 (alkaline) for the wireless remote
control
g Wireless remote control with holder
h Mounting plate (attached on the unit)
i Screw cover
j Spare SSID sticker with release paper (attached to the
unit)
▪ Spare SSID sticker. Do NOT throw away the spare sticker. Keep
it in a safe place in case it is needed in future (e.g. in case the
front grille was replaced attach it to the new front grille).
4 About the unit
WARNING: MILDLY FLAMMABLE MATERIAL
The refrigerant inside this unit is mildly flammable.
4.1 Operation range
Use the system in the following temperature and humidity ranges for
safe and effective operation.
Cooling and
drying
(a)(b)
Heating
(a)
Outdoor temperature –10~46°C DB –30~24°C DB
–31~18°C WB
Indoor temperature 18~37°C DB
14~28°C WB
10~30°C DB
Indoor humidity ≤80%
(a)
—
(a) A safety device might stop the operation of the system if the unit
runs outside its operation range.
(b) Condensation and water dripping might occur if the unit runs
outside its operation range.
4.2 About the wireless LAN
For detailed specifications, installation instructions, setting methods,
FAQ, declaration of conformity and the latest version of this manual,
visit
app.daikineurope.com .
INFORMATION: Declaration of conformity
▪ Daikin Industries Czech Republic s.r.o. declares that
the radio equipment type inside of this unit is in
compliance
with Directive 2014/53/EU and
S.I. 2017/1206: Radio Equipment Regulations 2017.
▪ This unit is considered as combined equipment
according to the definition of Directive 2014/53/EU and
S.I. 2017/1206: Radio Equipment Regulations 2017.
4.2.1 Precautions when using the wireless LAN
Do NOT use near:
▪ Medical equipment. E.g. persons using cardiac pacemakers or
defibrillators. This product may cause electromagnetic
interference.
▪ Auto-control equipment. E.g. automatic doors or fire alarm
equipment. This product may cause faulty behaviour of the
equipment.
▪ Microwave oven. It may affect wireless LAN communications.
4.2.2 Basic parameters
What Value
Frequency range 2400 MHz~2483.5 MHz
Radio protocol IEEE 802.11b/g/n
Radio frequency channel 1~13
Output power 13 dBm
Effective radiated power 15 dBm (11b) / 14 dBm (11g) /
14 dBm (11n)
Power supply DC 14 V / 100 mA
5 Unit installation
INFORMATION
If you are not sure how to open or close parts of the unit
(front panel, electrical wiring box, front grille…) refer to the
installer reference guide of the unit for opening and closing
procedures. For location of the installer reference guide
see
"1.1 About this document" [
4
2].
WARNING
Installation shall be done by an installer, the choice of
materials and installation shall comply with the applicable
legislation. In Europe, EN378 is the applicable standard.
5.1 Preparing the installation site
WARNING
The appliance shall be stored so as to prevent mechanical
damage and in a well-ventilated room without continuously
operating ignition sources (e.g. open flames, an operating
gas appliance, or an operating electric heater). The room
size shall be as specified in the General safety precaution.
5.1.1 Installation site requirements of the
indoor unit
INFORMATION
The sound pressure level is less than 70 dBA.
▪ Air flow. Make sure nothing blocks the air flow.
▪ Drainage. Make sure condensation water can be evacuated
properly.
▪ Wall insulation . When conditions in the wall exceed 30°C and a
relative humidity of 80%, or when fresh air is inducted into the
wall, then additional insulation is required (minimum 10 mm
thickness, polyethylene foam).
▪ Wall strength. Check whether the wall or the floor is strong
enough to support the weight of the unit. If there is a risk, reinforce
the wall or the floor before installing the unit.
▪ Spacing. Install the unit at least 1.8 m from the floor and keep the
following requirements in mind for distances from the walls and
the ceiling: