6
Installation site
•
It is possible that signals will not be received in
rooms that have electronic fluorescent lighting.
Please consult with your local dealer before
buying new fluorescent lights.
•
If the remote controller operated some other
electrical apparatus, move that machine away
or consult your local dealer.
•
Do not install the remote controller in places
exposed to direct sunlight. Doing so could
result in discolouration and failure of the LCD.
Loading the batteries
1.
Slide the front cover
and remove it.
2.
Put 2 dry cell
batteries AAA. LR03
(alkaline).
3.
Replace the front
cover.
2
3
1
Position and
correctly!
Mounting the remote
controller holder on a
wall
1.
Select a place from
where the signals
will reach the unit.
2.
Use locally purchased
screws to fasten the
holder to a wall, pillar
or similar surface.
3.
Place the remote
controller in the
remote controller
holder.
Wireless remote
controller
Remote
controller holder
Screws
When to change batteries
Under normal use, batteries last about a year.
However, change them whenever the indoor unit
doesn’t respond or responds slowly to commands,
or if the display becomes dark.
[CAUTIONS]
•
Replace all batteries at the same time, do
not use new and old batteries intermixed.
•
In case the remote controller is not used for
a long time take out all batteries in order to
prevent liquid leak of the battery.
IN THE CASE OF CENTRALIZED
CONTROL SYSTEM
If the indoor unit is under centralized control, it is
necessary to switch the remote controller’s setting.
In this case, contact your local dealer.
5. OPERATION RANGE
If the temperature or the humidity is beyond the
operation range*, safety devices may work and the
air conditioner may not operate, or sometimes, water
may drop from the indoor unit.
*Refer to the operation range shown in the operation
manual attached to the indoor or outdoor unit.
6. INSTALLATION SITE
Refer to operation manual attached to the indoor
unit.
7. OPERATION PROCEDURE
•
Operation procedure varies with heat pump
type and cooling only type. Contact your local
dealer to confirm your system type.
•
To protect the unit, turn on the main power
switch 6 hours before operation.
•
Do not shut off the power supply during
seasonal use of the air conditioner.
This is required in order to activate the air
conditioner smoothly.
•
If the main power supply is turned off during
operation, operation will restart automatically
after the power turns back on again.
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY OPERATION
Operate in the following order.
•
Operation modes supported depend on the
model that is connected.
•
For cooling only type, “COOLING”, “FAN” and
“PROGRAM DRY” operation are able to select.
FOR SYSTEMS WITHOUT COOL/HEAT
CHANGEOVER REMOTE CONTROL
SWITCH
Refer to Fig. 1-2 on page [1]
1
OPERATION MODE
SELECTOR
Press OPERATION MODE SELECTOR button
several times and select the OPERATION
MODE of your choice as follows.
COOLING OPERATION ............................ “ ”
The recommended set temperature is 26 to 28°C.
HEATING OPERATION .............................“ ”
The recommended set temperature is 18 to 23°C.
