Daihen OTC Welbee Inverter W400, Owner'S Manual

Page: 107 / 158

6-41
Chapter 6 W
elding Condition
S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
• To the internal function F46, set the time for initial welding in the range of 0.0 to 10.0 seconds. Set the value
in the range of 0.0 to 10.0 seconds.
• To the internal function F47, set the crater treatment time in the range of 0.0 to 10.0 seconds. Set the value
in the range of 0.0 to 10.0 seconds.
TIPS
• When the internal function F45 is set to [ON], automatically the setting of "No crater" is
selected, disabling other welding modes. (The CRATER-FILL key does not work.)
• Welding method at crater treatment is the same as that of main welding.
• In the following cases, this function cannot be used:
– Internal function F11 (Fine adjustment of welding conditions memory) is set to "1" to "30" (enabled);
– Internal function F44 (Reading welding condition with remote control) is set to "ON" (enabled);
– Internal function F48 (Adjusting current with torch switch) is set to "ON" (enabled); or
– Internal function F51 (Special crater repeat) is set to "ON" (enabled); or
– Either of the internal function F29 to F32 (External input terminal setting) is set to "5" (Loading welding
condition).
6.7.2.30 F48: Adjusting current with torch switch
Increases/decreases the welding current by the torch switch operation.
• [ON]: the setting of "CRATER-FILL ON" is selected, enabling to increase or decrease welding current by
single-clicking or double-clicking the torch switch in the period of welding condition (during start input
holding)
If this function is enabled, the LED of "CRATER-FILL ON" of the CRATER-FILL key flashes.
Set the increase/decrease current volume through F49 (Current increase and decrease by single-clicking)
and F50 (Current increase and decrease by double-clicking).
• [OFF]: disables the function.
㩷
㩷 㩷
㩷
ON
OFF
Torch switch
Gas flow
Output voltage
Wire feeding speed
Welding current
Pre-flow
Post-flow
Anti-stick time
No-load voltage
Slow-down speed
Crater-fil
㫃
Main welding
Initial current
Crater-fill current
Welding current
Initial condition
Set the time by F46
( 0.0 to 10.0 seconds)
Set the time by F47
( 0.0 to 10.0 seconds)