D
ATA
B
ACKUP
(U
TILIZATION
OF
DATA
)
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
7-12
TIPS
• It is not possible to separately save the welding condition data recorded in memory and the
internal function setting data. Both of the data will always be written in the
"DAIHEN_OTC_WELDING_PARAMETER.CSV" file.
• When importing the backup data to the welding power source, both or either of the data
above can be imported at one time.
"ALL": Welding condition data recorded in Internal function setting data
"1": Welding condition data recorded in memory
"2": Internal function setting data
7.3.2 Simplified data log function
The welding status can be checked on a computer by sampling the data during welding and backing
them up in the USB memory. Only three of the following data can be sampled.
The data types/sampling speed should be specified in the internal function F52/F53 (data log function).
(
-
Simplified data log will be created below the "DAIHEN_OTC_Welbee\DAT\DAT00001" folder. A csv
file will be created per welding.
When DAIHEN_OTC_Welbee\DAT\DAT00001 folder is already existing, "DAT00002" folder will be
created below the "DAIHEN_OTC_Welbee\DAT" folder and folder for the consecutive number will per
created for each simplified data log.
Example: The data will be output as below when the internal function F52 is set to "1" (detected values
of welding current, welding voltage and feeding speed) and F53 to "2" (100 ms).
• Welding current set value
• Welding voltage set value
• Wire feeding speed set value
• Welding current actual value • Welding voltage actual value • Wire feeding speed actual value
Start of welding
Elapse of
time
Time [msec]
Welding current [A]
Welding current [V]
Feeding rate [m/min]
Summary of Contents for OTC Welbee Inverter W400
