Daihen OTC Welbee Inverter W400, Owner'S Manual

Page: 21 / 158

2-5
Chapter 2
Product Specification
and Configuration
P
RODUCT
C
ONFIGURATION
P
RODUCT
S
PECIFICATION AND
C
ONFIGURATION
C
HAPTER
2
2.2 Product Configuration
This section explains the standard or optional composition of the welding power source and parts to be
prepared by customers.
2.2.1 Standard composition
This section explains the standard composition of the welding power source.
For equipment used in combination with the welding power source connected to robot, refer to the
instruction manual of the robot controller.
• When air-cooled welding torch is used
• Use this welding power source in combination with the specified wire feeder.
Connecting to any equipment other than specified may cause failure of the welding
power source.
No. Name
Supplied unit
(*1)
Optional
accessories
Remarks
1 Gas regulator
To be prepared by the customer.
(
2.2.2
-
Accessory (not
supplied))
2 Wire feeder
○
3 Welding torch ○
4 Gas hose (3 m)
○
(*2)
5 Control cable for wire feeder (1.5 m) ○ (*2)
6 Power cable for torch side (2 m)
○
(*2)
7 Power cable for base metal side (2 m) ○ (*2)
8 Shielding gas
To be prepared by the customer.
(
2.2.2
-
Accessory (not
supplied))
9 Digital remote control (optional)
○ ( 2.2.3
-
Optional accessories)
10 Analog remote control (3 m) (optional)
○
(*2)
*1: Standard component with welding power source. (Supplied when placing order for the welding power source)
6
7
10
5
2
4
1
8
3
9
Base metal
Welding power source
Ground a base metal if
required by local law.