No.P6972
P. 16/ 64
Used to set welding
current.
Pressing this switch
causes only wire to be
fed. The wire feed
speed can be changed
by the left knob.
[ONE-KNOB]
Setting to the mark “
•
” causes optimum
voltage to be obtained automatically.
Rotate
the knob clockwise to increase the voltage, or
counter-clockwise to decrease the voltage.
[SEPARATE]
The scale is divided into 10 equal parts toward
the maximum output voltage. Rotating
clockwise causes welding voltage to become
higher.
[FUZZY(ALUM.)]
Setting is unnecessary.
CPDP-350
Same operation as CPDP-500, but only different scale at
“A”
knob
.
In case of using the “ONE-KNOB” mode
When the “CURR.VOLT. CONTROL” switch of the front panel is set to the “ONE-KNOB” side,
the optimum welding voltage can be set automatically according to “A” knob of the remote
control box. When a fine adjustment of welding voltage is desired, adjust the “V” knob.
In case of using the “SEPARATE” mode
Set the “CURR.VOLT. CONTROL” switch provided on the front panel to the “SEPARATE”
side, and the welding current and voltage can be adjusted separately.
In case of using the “FUZZY(ALUM.)” mode
When the “CURR.VOLT. CONTROL” switch of the front panel is set to the “FUZZY(ALUM.)”
side, the optimum welding voltage can be set automatically according to “A” knob of remote
control box in fuzzy theory. In this case, the right knob of the remote control box does not work.
