－
23
－
9. WELDING PREPARATION
(Continued)
9.3 Coolant
（
1
）
Use coolant
Please use DAIHEN’S genuine coolant.
Because the DAIHEN’S genuine coolant is mixture of the pure water and anti-freeze
liquid in special portion to prevent from freezing and rusting due to the germs
※
Notice) Please do not use the dirty water, industrial water and low quality coolant. In
these cases, the blocking might occur in torch.
9.4 Inching Operation
CAUTION
Refer to the manual of the wire feeder for detailed usage method and precautions for the
wire feeder.
⚫
Do not watch whether the wire is feeding while inching. A welding wire
suddenly sticking out may cause injury to your face or eyes.
⚫
Keep your face, eyes and body away from the welding torch, which
otherwise may cause injuries.
⚫
Keep your hands, fingers, hair, clothes, etc. away from the rotating parts
when inching, because they otherwise may be caught into the rotating parts
and therefore cause danger.
1)
After straightening the welding torch cable, feed the wire by
keeping pressing the INCHING key (the LED lights up).
2)
When the wire from the contact tip sticks out (about 10 mm),
stop feeding by releasing the INCHING key (the LED goes
off).
3)
Wire feeding speed can be adjusted by the CURRENT
adjusting knob while the INCHING key is pressed down.
When you use analog remote control box instead of the control
panel, you can adjust by the switch and knob on the remote box.
In this case the adjust knob on the control panel will be invalid.
Inching key
Adjusting knob
