Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 20 / 188

P
RODUCT
C
ONFIGURATION
P
RODUCT
S
PECIFICATION AND
C
ONFIGURATION
C
HAPTER
2
18
2.2 Product Configuration
This section explains the standard or optional composition of the welding power source and parts to be prepared by
customers.
2.2.1 Standard composition
This section explains the standard composition of the welding power source.
For equipment used in combination with the welding power source connected to robot, refer to the instruction manual of
the robot controller.
• When air-cooled welding torch is used
CAUTION
• Use this welding power source in combination with the specified wire feeder.
Connecting to any equipment other than specified may cause failure of the welding
power source.
No. Name
Accessory
(supplied) (*1)
Supplied unit
(*2)
Optional
accessories
Remarks
1 Voltage detection cable
○
2 Gas regulator
To be prepared by the customer.
(
2.2.3
-
Accessory (not supplied))
3 Wire feeder
○
4 Welding torch
○
5 Gas hose (3 m)
○
(*3)
6 Power cable for torch side (2 m)
○
(*3)
7 Control cable for wire feeder (1.5 m)
○
(*3)
8 Control cable for touch panel (4 m)
○
(*3)
9 Power cable for base metal side (2 m)
○
(*3)
10 Shield gas
To be prepared by the customer.
(
2.2.3
-
Accessory (not supplied))
11
Digital remote control (optional)
○
E-2454
(
2.2.4
-
Optional accessories)
12 Analog remote control (3 m) (optional)
○
K5804S00 (*3)
*1: The voltage detection cable is not needed except for the DC low spatter welding.
*2: Standard component with welding power source. (Supplied when placing order for the welding power source)
7
8
7
5
9
6
6
10
2
12
12
1
4
3
8
11
Welding
power source
Base metal
Ground a base metal if
required by local law.
Welding
power source
(rear side)