Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 103 / 188

S
ETTING
W
ELDING
JOB
W
ELDING
C
ONDITION
C
HAPTER
6
101
Chapter 6 W
elding Condition
4.
Select OK.

The weld joint and plate thickness settings are registered and the screen returns to the HOME screen.
T I P S
• There is an upper and lower limit for the plate thickness that can be set.
•
The Welding guide function cannot be used depending on the combination of welding JOB.
• The Welding guide function cannot be used when an analog remote control (optional
accessory) is connected.
6.6.11 Water cooling
This section explains how to set the "Water cooling" settings.
By setting "Water cooling", the welding power supply enters the water-cooled welding torch mode.
1.
Others > Water cooling

The welding power supply enters the water-cooled welding torch mode.

During "Water cooling", the "Water cooling" icon appears at the top of this screen and the HOME screen.
•
To switch to the air-cooled welding torch mode: Select "Water cooling" again to switch to OFF.