WEB Client 42
Start Coil IO
Select Start Coil IO butnot select Start RS485 Port.
The
Setting
interface is displayed. See Figure 5-24.
I/O (Start Coil IO)
Configure the parameters. Please refer to Table 5-13 for more details.
Table 5-13 Coil IO parameters description
Parameter
Note
Trigger
Mode Config
IO
Select IO, and only
Coil IO
can be selected here.
Coil 1
Set the coil trigger mode.
No trigger: No snapshot is triggered.
Rise Edge: Snapshot is triggered when the vehicle enters
coil.
Fall Edge: Snapshot is triggered when the vehicle exits coil.
When the scheme is
Single_in_1 snapshot
, then coil 2 can not
be set.
Coil 2
IO Config
Scheme
Set IO snapshot scheme.
Single_in 1 snapshot: Lay single coil and it will take
snapshot when the vehicle enters coil.
Vehicle_double_in 1 snapshot: Lay double coil and it will
take snapshot when the vehicle enters the first coil.
Vehicle_double_in 2 snapshot: Lay double coil and it will
take snapshot when the vehicle enters the second coil.
Coil Map
Select the corresponding relationship between logical coil and
physical coil.
Click
OK
to finish configuration.
Start RS485 and coil IO at the same time
Select Start Coil IO and Start RS-485 Port at the same time, and then it can realize the vehicle
snapshot config of coil IO and RS-485 port config. See Figure 5-25.
