ESS3016X User’s Manual
69
Figure 8-1
2) In web configuration interface, from disk management to RAID configuration, you can see
current RAID device status.
Before hot swap, please
make sure
the disk to be hot swapped is in RAID5 (RAID1) and RAID5
(RAID1) is in working status. See Figure 8-2.
Figure 8-2
3). Log out disk to be hot swapped.
In Figure 8-2, click edit button of the corresponding RAID device. You can see an interface is
shown as in Figure 8-3.
Here you can see the following information:
z
RAID 5 device md0 total space is 698.66, and it consists of four disks.
z
The RAID status is in working status. (Clean mode).
z
The group consists of four disks: disk1, disk2, disk3, disk4.
z
There is a newly added disk list.
Check remove button after disk1 and then click save button. Now you are about to remove disk1.
