10
4. Gire el interruptor del panel de control a ON.
a. La unidad del generador es de arranque eléctrico y
se puede arrancar girando el interruptor a la posición
START. Para prolongar la vida útil de la batería, no gire
el interruptor durante más de 3 segundos y el intervalo
entre dos intentos debe estar por lo menos a 10
segundos de distancia.
b. Para el generador de arranque manual, tire del
agarre de arranque de retroceso hasta que el motor
funcione. NOTA: No permita que la empuñadura se
suelte de nuevo después de arrancar; Regresa suave-
mente a su lugar original. Deje que el motor funcione
durante 10-20 segundos, luego mueva la palanca del
estrangulador a la posición RUN.
5.Para operar el equipo eléctrico, encienda el disyun-
tor. Tenga en cuenta que utliza varios aparatos al
mismo tiempo, no agregue el siguiente a menos que el
generador y otros elementos se estén ejecutando
normalmente. La potencia total de las cargas no debe
exceder la potencia nominal de la unidad.
9. OPERACIÓN
Arranque del motor
1. Desenchufe todas las cargas del generador.
2. Gire la válvula de combustible a la
posición ON.
3. Mueva la palanca del estrangulador a la
posición CHOKE. NOTA: Si el motor ha estado
funcionando y se está reiniciando, deje la
palanca del estrangulador en la posición RUN.
Summary of Contents for GDA Series
