34
To stop the unit quickly in an emergency:
Turn the engine switch to the OFF position.
Warning:
The surface temperature of the generator
unit are still high after shutdown, and it should
not be moved or touched before cooling down to avoid
the possibility of burns.
The unit should be stored in a clean and dry place and
should be protected from rain and high temperature.
Covering the unit is recommended to avoid excessive
exposure to moisture and dust.
If the generator is not used regularly remove the fuel
via the drainage bolt of the carburetor and drain the
fuel tank. Then tighten the oil drainage bolt again. If a
quality fuel stabilizer is used then this procedure can
be ignored.
Stopping the Engine
1. Remove any load from the generator.
2. Turn the engine switch to the OFF position.
3. Turn the fuel valve to the OFF position.
Summary of Contents for GDA Series
