
33
4. Turn the switch on the control panel to ON.
a. The generator unit is electric. start and can be
started by turning the switch around to the START
position. In order to extend the service life of the
battery, do not turn the switch for more than 3
seconds and the interval between two attempts
should be at least 10 seconds apart.
b. For the manual start generator by pulling the recoil
starting grip until the engine runs. NOTE: Do not allow
the grip to snap back after starting; return it gently to
its original place. Allow the engine to run for 10-20
seconds, then move the choke lever to the RUN
position.
5. To operate electrical equipment, turn the circuit
breaker ON. Please note that when using several
appliances at the same time, do not add the next one
unless the generator and other items are running
normally. The total power of the loads should not
exceed the rated power of the unit.
9. OPERATING
Starting the Engine
1. Unplug all loads from the generator.
2. Turn the Fuel valve to the ON position.
3. Move the choke lever to the CHOKE position.
NOTE: If engine has been operating and
is being restarted leave the choke lever in the
RUN position.
Summary of Contents for GDA Series
