2-7
INSPECTIONS / ADJUSTMENTS
CARBURETOR IDLE SPEED
●
Remove the plug maintenance cover.
GEAR OIL REPLACEMENT
●
Remove the oil check bolt.
●
Remove oil drain bolt and drain oil completely.
●
Install and tighten the oil drain bolt.
TORQUE VALUE : 0.98kgf
·
m
DRIVE BELT
●
Remove the L.crankcase cover.
●
Check the drive belt for wear or damage. Check
scheduled maintenance period, replace the new drive
belt if possible.
●
Fill the recommended oil(SAE90#).
GEAR OIL CAPACITY
At disassembling: 200cc At replacing: 180cc
●
Erect the main stand prior to beginning work.
●
Stop the engine and remove the oil check bolt.
●
Check the oil level through the oil check hole.
●
If the oil level is below, fill the oil (SAE90#).
●
Install and tighten the oil check bolt.
FINAL REDUCTION GEAR OIL
IDLING SPEED: 1,700
±
100rpm
•
Verify all engine adjustments satisfy specifications.
Make adjustments, if necessary.
•
Heat the engine to make accurate idling inspection
and adjustment. Stand the vehicle on the main stand.
•
Turn the throttle stop screw and make adjustments to
prescribed idling speed.
•
Erect the main stand prior to beginning work.
•
Make sure that the sealing washer is good condition.
•
Make sure that the sealing washer is good condition.
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL CHECK BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
OIL DRAIN BOLT
Summary of Contents for S2-250
