DACE Compact, Manual

Page: 14 / 22

TO PROGRAM THE MOTOR. Ensure that all power is removed from the board.
1.
Manually open the gate 1m -1.5m This will be the pedestrian opening distance.
2. Lock the gate in place. (Operational mode.)
3. Insert the program jumper over the two pins on the P.C. Board called “prog motor”.
4. Apply the battery power. The status L.E.D. will flash rapidly.
5. Press the trigger button. on the P.C.BOARD. The gate will automatically do the following
6. A) Close slowly until the end stop is struck.
B) Open slowly until the end stop is struck.
7. When the motor is fully open. Remove the jumper from the prog motor pins.
8. Apply the AC mains power and ensure that the green “charge” led comes on.
The motor is now fully programmed and ready for normal use.
NOTE the programming procedure can be aborted at any stage simply by removing the battery wires. This will stop the motor and the
process can be re-started at any time.
In
step (6 A)
the gate must close first. If the gate opens first, then the
motor wires
must be reversed. This will change the motor direc-
tion. {See Setting the motor direction}
Do not connect any other trigger wires to the board until the motor is fully programmed.
1m
1. Open the gate manually 1m.—1.5m
2. While turning the thumb wheel anti clockwise, move the gate slightly until a
click is heard and the motor locks into place
3. Place the jumper over the “PROG” pins 4. Apply battery power.
Do not reverse polarity
5. Press the test button once
Drive to the open end
A
B
6. The gate will do the following automatically
Drive to the closed end
Remove the PROG jumper
8. Apply 16 volt AC power
7.When the motor is fully open
DO NOT APPLY 220VOLTS