D-Link DES-3010FA/GA CLI Reference Guide
Page 61
sntp server
The
sntp server
Global Configuration mode command configures the device to use the Simple Network Time
Protocol (SNTP) to request and accept SNTP traffic from a specified server. To remove a server from the list of
SNTP servers, use the
no
form of this command.
Syntax
sntp server
{
ip-address | hostname}
[
poll
] [
key
keyid
]
no sntp server
host
Parameters
•
ip-address
— IP address of the server.
•
hostname —
Hostname of the server. (Range: 1-158 characters)
•
poll —
Enable polling.
•
keyid —
Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the
sntp unicast client enable
Global Configuration mode command to enable predefined unicast clients
globally.
To enable polling you should also use the
sntp unicast client poll
Global Configuration mode command for glo-
bal enabling.
Polling time is determined by the
sntp client poll timer
Global Configuration mode command.
Examples
The following example configures the device to accept SNTP traffic from the server on 192.1.1.1.
Console(config)#
sntp server
192.1.1.1
Summary of Contents for DES-3010FA-TAA - Switch 10/100MBPS Mgmt
Page 1: ......
