Cypress PSoC CY8CTMG20 Series, Technical Reference Manual

Page: 24 / 308

24 PSoC CY8CTMG20x and CY8CTST200 TRM, Document No. 001-53603 Rev. *C
Section B: PSoC Core
Core Register Summary
This table lists all the PSoC registers for the CPU core in address order within their system resource configuration. The
grayed out bits are reserved bits. If you write these bits always write them with a value of ‘0’. For the core registers, the first ‘x’
in some
register addresses represents either bank 0 or bank 1. These registers are listed throughout this manual in bank 0,
even though they are also available in bank 1.
Summary Table of the Core Registers
Address Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Access
M8C REGISTER (page 27 )
x,F7h CPU_F PgMode[1:0] XIO_1 XIO Carry Zero GIE RL : 02
RAM PAGING (SRAM) REGISTERS (page 39 )
x,6Ch TMP_DR0 Data[7:0] RW : 00
x,6Dh TMP_DR1 Data[7:0] RW : 00
x,6Eh TMP_DR2 Data[7:0] RW : 00
x,6Fh TMP_DR3 Data[7:0] RW : 00
0,D0h CUR_PP Page Bits[2:0] RW : 0
0,D1h STK_PP Page Bits[2:0] RW : 0
0,D3h IDX_PP Page Bits[2:0] RW : 0
0,D4h MVR_PP Page Bits[2:0] RW : 0
0,D5h MVW_PP Page Bits[2:0] RW : 0
INTERRUPT CONTROLLER REGISTERS
(page 45 )
0,DAh INT_CLR0 I2C Sleep SPI GPIO Timer0 TrueTouch Analog V Monitor RW : 00
0,DBh INT_CLR1 Endpoint3 Endpoint2 Endpoint1 Endpoint0 USB SOF USB Bus Rst Timer2 Timer1 RW : 00
0,DCh INT_CLR2 USB_WAKE Endpoint8 Endpoint7 Endpoint6 Endpoint5 Endpoint4 RW : 00
0,DEh INT_MSK2
USB
Wakeup
Endpoint8 Endpoint7 Endpoint6 Endpoint5 Endpoint4 RW : 00
0,DFh INT_MSK1 Endpoint3 Endpoint2 Endpoint1 Endpoint0 USB SOF
USB Bus
Reset
Timer2 Timer1 RW : 00
0,E0h INT_MSK0 I2C Sleep SPI GPIO Timer0 TrueTouch Analog V Monitor RW : 00
0,E1h INT_SW_EN ENSWINT RW : 0
0,E2h INT_VC Pending Interrupt[7:0] RC : 00
GENERAL PURPOSE I/O (GPIO) REGISTERS (page 59 )
0,00h PRT0DR Data[7:0] RW : 00
0,01h PRT0IE Interrupt Enables[7:0] RW : 00
0,04h PRT1DR Data[7:0] RW : 00
0,05h PRT1IE Interrupt Enables[7:0] RW : 00
0,08h PRT2DR Data[7:0] RW : 00
0,09h PRT2IE Interrupt Enables[7:0] RW : 00
0,0Ch PRT3DR Data[7:0] RW : 00
0,0Dh PRT3IE Interrupt Enables[7:0] RW : 00
1,00h PRT0DM0 Drive Mode 0[7:0] RW : 00
1,01h PRT0DM1 Drive Mode 1[7:0] RW : FF
1,04h PRT1DM0 Drive Mode 0[7:0] RW : 00
1,05h PRT1DM1 Drive Mode 1[7:0] RW : FF
1,08h PRT2DM0 Drive Mode 0[7:0] RW : 00
1,09h PRT2DM1 Drive Mode 1[7:0] RW : FF
1,0Ch PRT3DM0 Drive Mode 0[7:0] RW : 00
1,0Dh PRT3DM1 Drive Mode 1[7:0] RW : FF
0,10h PRTxDR Data[7:0] RW : 00
0,11h PRTxIE Interrupt Enables[7:0] RW : 00
1,10h PRTxDM0 Drive Mode 0[7:0] RW : 00
1,11h PRTxDM1 Drive Mode 0[7:0] RW : 00
[+] Feedback